Circle

A circle is the set of points in a plane that are equidistant from a given point . The distance from the center is called the radius, and the point is called the center. Twice the radius is known as the diameter . The angle a circle subtends from its center is a full angle, equal to or radians.

A circle has the maximum possible area for a given perimeter, and the minimum possible perimeter for a given area.

The perimeter of a circle is called the circumference, and is given by

(1)

This can be computed using calculus using the formula for arc length in polar coordinates,

(2)

but since , this becomes simply

(3)

The circumference-to-diameter ratio for a circle is constant as the size of the circle is changed (as it must be since scaling a plane figure by a factor increases its perimeter by ), and also scales by . This ratio is denoted (pi), and has been proved transcendental.

Knowing , the area of the circle can be computed either geometrically or using calculus. As the number of concentric strips increases to infinity as illustrated above, they form a triangle, so

(4)

This derivation was first recorded by Archimedes in Measurement of a Circle (ca. 225 BC).

If the circle is instead cut into wedges, as the number of wedges increases to infinity, a rectangle results, so

(5)

From calculus, the area follows immediately from the formula

(6)

again using polar coordinates.

A circle can also be viewed as the limiting case of a regular polygon with inradius and circumradius as the number of sides approaches infinity (a figure technically known as an apeirogon). This then gives the circumference as

			(7)
			(8)

and the area as

			(9)
			(10)

which are equivalently since the radii and converge to the same radius as .

Unfortunately, geometers and topologists adopt incompatible conventions for the meaning of "-sphere," with geometers referring to the number of coordinates in the underlying space and topologists referring to the dimension of the surface itself (Coxeter 1973, p. 125). As a result, geometers call the circumference of the usual circle the 2-sphere, while topologists refer to it as the 1-sphere and denote it .

The circle is a conic section obtained by the intersection of a cone with a plane perpendicular to the cone's symmetry axis. It is also a Lissajous curve. A circle is the degenerate case of an ellipse with equal semimajor and semiminor axes (i.e., with eccentricity 0). The interior of a circle is called a disk. The generalization of a circle to three dimensions is called a sphere, and to dimensions for a hypersphere.

The region of intersection of two circles is called a lens. The region of intersection of three symmetrically placed circles (as in a Venn diagram), in the special case of the center of each being located at the intersection of the other two, is called a Reuleaux triangle.

In Cartesian coordinates, the equation of a circle of radius centered on is

(11)

In pedal coordinates with the pedal point at the center, the equation is

(12)

The circle having as a diameter is given by

(13)

The parametric equations for a circle of radius can be given by

			(14)
			(15)

The circle can also be parameterized by the rational functions

			(16)
			(17)

but an elliptic curve cannot.

The plots above show a sequence of normal and tangent vectors for the circle.

The arc length , curvature , and tangential angle of the circle with radius represented parametrically by (◇) and (◇) are

			(18)
			(19)
			(20)

The Cesàro equation is

(21)

In polar coordinates, the equation of the circle has a particularly simple form.

(22)

is a circle of radius centered at origin,

(23)

is circle of radius centered at , and

(24)

is a circle of radius centered on .

The equation of a circle passing through the three points for , 2, 3 (the circumcircle of the triangle determined by the points) is

|x^2+y^2 x y 1; x_1^2+y_1^2 x_1 y_1 1; x_2^2+y_2^2 x_2 y_2 1; x_3^2+y_3^2 x_3 y_3 1|=0.

(25)

The center and radius of this circle can be identified by assigning coefficients of a quadratic curve

(26)

where and (since there is no cross term). Completing the square gives

(27)

The center can then be identified as

			(28)
			(29)

and the radius as

(30)

where

			(31)
			(32)
			(33)
			(34)

Four or more points which lie on a circle are said to be concyclic. Three points are trivially concyclic since three noncollinear points determine a circle.

In trilinear coordinates, every circle has an equation of the form