Encoder Rotary optic 

Nuevo artículo publicado. La segunda parte de una trilogía sobre la importancia de la correcta gestión de las reparaciones. Lee y comparte tu opinión

Currents and power analysis are key factors in any design or redesign of an installation they will enable the source(s) to be sized according to the purpose of the installation...

Keep on reading:

http://electrical-engineering-portal.com/calculation-currents-power-load-type

The motor must have enough breakaway torque to start the load. This is not related to the motor locked rotor or starting torque published for across-the-line starting.

Keep reading:

http://electrical-engineering-portal.com/correct-motor-selection-adjustable-speed-drive

Electrical engineering, like any job in technology, contains a lot of technical questions. Your safest bet to be successful at an electrical engineering interview is to brush up on your technical knowledge and review any of the latest updates in the field. You are going to be tested on what you can do, because your job is too important to be given to someone without the right technical knowledge.

In this video are some of the questions you may be asked at a job interview, including a few technical questions to get you started.


Build your own Mitutoyo / Igaging Digimatic Arduino interface:

Calipers, scales, micrometers, dial indicators, you can have it all!

New code, new board (with onboard arduino nano), new video!

http://arduinotronics.blogspot.com/2015/09/igaging-micrometers-and-calipers.html

Many different system designs are possible, but for highest reliability, systems are typically configured so that generator set(s) are connected at low voltage, with the minimum number of transformers...

Keep reading:

http://electrical-engineering-portal.com/connecting-generator-sets-low-voltage-system